TWP Inc.

More....

All you need to know about Micronic Wire Mesh

OVERVIEW

TWP INC offers precisely woven Dutch weave stainless steel filter cloth. These Dutch weaves (TDW and PDW) are thick meshes with small curved tunnel shaped openings. Light doesn’t pass well through these meshes.

* 

• Hydraulic fluid filters - use TDW and PDW weave types
• Gas diffusers - use TDW and PDW weave types single layer or stacked
• Breather vents

* _if you need non-fraying micronic meshes, please see http://www.twpinc.com/twpinc/control/category/%7Ecategory_id=TWPCAT_13" target="_blank">sintered section.

Micronic Wire Mesh - Cutting

Micronic wire meshes are easily cut with sharp hand tools. Choose your metal, weave type and opening size

• Metals
  • Alloy Type 304 or Type 316
    • T304 is the basic stainless alloy, and unless otherwise specified it is assumed that this type is acceptable. Also called 18-8 due to 18% chromium and 8% nickel. T304 melts at 2600 degrees F (1430 C) but its maximum recommended temperature for continuous service is 1450 degrees F. (790 C) and is useful for intermediate service up to 1650 degrees F (900 C). Its' uses include: sorting and screening of abrasives, liquids, powders and other solids.
    • T316 is a special stainless alloy due to the addition of 2% molybdenum. This increases its resistance to corrosion by salts, acids and seawater. Also called 18-10 due to 18% chromium and 10% nickel. T316 melts at 2500 degrees F (1375 C) but its maximum recommended temperature for continuous service is 1500 degrees F. (815 C) and is useful for intermediate service up to 1650 degrees F (900 C). Its' uses include: processing of oils, chemicals, food and pharmaceuticals.
  • In general, T316 can always be substituted for T304.
• Weave type
  • Micronic (Dutch Weaves PDW and TDW) - The dutch weaves (PDW, TDW) are thick, strong; light-tight meshes which are used primarily in fluid, vacuum, and pressure filtration of liquids and gases. These are woven to precise tolerances and their openings are actually tiny curved, triangular tunnels. * 
• Opening Size
  • Absolute Filtration Rating - A measure of retention, expressed in microns, that specifies the equivalent diameter of the smallest particle from which the filter has a retention of 100%. In actual practice, most manufacturers assign absolute ratings on the basis of retention in the range from 98% - 99.999999%.
  • Nominal Filter Rating - A measure of retention, expressed in microns, that specifies the equivalent diameter of the smallest particle for which the filter has a retention somewhere in the range of 60-90%. Nominal filter rating is imprecise.

Micronic Wire Mesh - Discs

• 500 standard disc diameters
• Same day delivery on stock items
• Tolerance to +/- .001 inch
• Clean edged cutting on wire mesh as fine as .00078 inch wire diameter
• Special diameters in three days

Micronic Wire Mesh - Samples

TWP Inc. will provide samples for your testing and inspection. The cost is $8 per sample ordered (plus UPS Charges about $3.00 total for up to 10 samples by UPS ground - USA). For the quickest service, please order your samples on-line.

All micronic samples are 3" x 3" with the exception of stainless steel 635 mesh which is a one inch square.

Our "Quot-O-Matic" Disc pricer can get you quick quotes by phone. To get an email quote for micronic mesh discs: You will need to indicate material, disc diameter, mesh and quantity or contact us by phone or fax.